







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cabinets & Countertops in Placentia, CA: What to Expect
New cabinets and countertops in Placentia usually run $14,000 to $45,000 for a full tear-out and replacement, and most jobs take two to four weeks from demo to the last caulk line. The work moves in a fixed order: templating happens after cabinets are set, countertops are cut off-site, and the gap between the two is where timelines are won or lost. Call (888) 300-3178 and we’ll walk your kitchen and put real numbers in writing.

How the job actually runs, stage by stage

Kitchen work order matters more than fancy finishes. Here’s the sequence we follow on a Placentia cabinet and countertop replacement, with the timing homeowners should plan around.
Stage 1 – Walkthrough and field measure (day 1, about 90 minutes). We measure walls, check for out-of-square corners, and note where the old plumbing and outlets sit. You decide box color, door style, and whether you’re keeping the same layout. This is also where we flag anything behind the drywall that could change the plan. In older Placentia ranch homes, that’s often galvanized supply lines or a slab that isn’t level.
Stage 2 – Demo and prep (days 2 to 3). Old cabinets, countertops, and backsplash come out. We cap the plumbing, pull the old fasteners, and patch and float the wall so new boxes sit flat. If a floor is soft, we open it and fix it now rather than shim over it. You pick the countertop slab or color at this stage so the fabricator can start the moment we hand off a template.
Stage 3 – Cabinet set and template (days 4 to 7). Base and wall cabinets go in, leveled and shimmed to the wall, then screwed together in a continuous run. Once boxes are locked in, the countertop fabricator comes out to template. You’ve already chosen your material and edge profile. This template is the single point where a wrong fridge-size decision can cost you weeks, so it happens last, never first.
Stage 4 – Fabrication and install (days 10 to 14, depending on shop load). Countertops are cut and polished off-site. The fabricator returns with the slabs, sets them over the cabinet run, and cuts in the sink, faucet, and cooktop openings. Under-mount sink brackets are set at this point. Caulking to the wall happens here too, but only after you’ve signed off on the fit.
Stage 5 – Finish and punch (days 15 to 20). Backsplash, if it’s in scope, gets set. Hardware goes on, end panels and crown get touched up, and we do a walkthrough against the written scope. Anything on the punch list gets fixed before final payment. You’ll have a clear picture of what was promised, and we close it out item by item.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll actually weigh
- Stock vs. semi-custom vs. full custom boxes. Stock gets you in fastest and cheapest; you’re locked to standard widths, which in a small 1950s Placentia kitchen often means filler strips to kill the gaps. Semi-custom lets you adjust widths and heights; that’s usually the sweet spot for a room that wasn’t designed around modern cabinet dimensions. Full custom makes sense when the layout is unusual or you want a very specific door style. Expect a meaningful jump each step up.
- Door material and finish. Painted MDF takes a clean, flat look and is easy to repaint if you change your mind down the road. Solid wood doors take the nicks of a busy household better and can be sanded and refinished. Thermofoil is the value pick but doesn’t love heat, so we don’t put it near a range hood that runs hot.
- Quartz vs. granite vs. butcher block. Quartz holds up to staining and doesn’t need sealing. It doesn’t love direct heat, so hot pans need a trivet. Granite handles heat better and each slab is one of a kind, but it requires periodic sealing. Butcher block is warm and repairable, but you’ll oil it regularly. All three work fine on slab-on-grade floors, but heavier granite means a stouter cabinet base.
- Sink and faucet setup. Under-mount sinks look cleaner and are easier to wipe into. Drop-in sinks are cheaper to install and simpler to swap later. Faucet finish matters less than valve quality; a good cartridge is what stops drips five years from now.
What cabinets and countertops cost in Placentia, CA
Most Placentia cabinet and countertop replacements land between $14,000 and $45,000, all-in. Here’s where the range breaks down.
| Line item | Typical range |
|---|---|
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
The four things that push a job toward the high end are: room size and cabinet run length (more boxes, more labor), the condition of what’s behind the walls (galvanized plumbing or soft floor means replacing it), material grade of the countertop and doors, and whether we’re relocating plumbing, gas, or electrical. Moving a sink six feet is not the same job as leaving it where it is. A permit adds cost and time when walls or utilities change.

Your written estimate should spell out cabinet brand and door style, countertop material and edge, sink and faucet if included, demo and haul-away, and any plumbing or electrical allowance. It should also state what it doesn’t cover: appliance hookups, drywall repair beyond the cabinet footprint, and any structural fix found mid-job. If a contractor won’t put those in writing before you sign, that’s the red flag. Call (888) 300-3178 for a free estimate.
See the difference
Before
After
Before
After
Before
AfterWhat Placentia homes specifically do to this job
Most of the kitchens we work on in Placentia sit inside 1950s to 1970s single-story ranch homes on tight infill lots, and that build era changes the job. Many of those houses still have original galvanized supply lines, so a cabinet swap is often the moment a homeowner decides to re-pipe instead of waiting for a leak behind a brand-new box. Slab foundations in the older core are common, and cabinets set over a slab need to be leveled and shimmed rather than nailed to a subfloor. Placentia’s permitting process also scrutinizes lot coverage and setbacks closely, so anything that changes the exterior footprint or adds a structural opening triggers permits and inspection windows. If the kitchen sits off a former garage slab, it’s worth checking thickness and rebar before we set heavy base cabinets or a stone island. If you’re also planning to reclaim that garage, this is often the moment to look at a Garage Conversion ADU in Placentia, or a New Detached ADU in Placentia if the lot allows it. Placentia’s hot, dry summers dry out wood framing and that’s a good reason to check for soft studs or cracked door stiles before the new boxes go in. We cover both ZIP codes, 92871 and 92870, and can walk your kitchen in Placentia. For the full scope of a larger project, see our Kitchen Remodeling service, and for the broader Placentia coverage, Kitchen Remodeling in Placentia.
Serving Placentia, CA – Our Local Coverage Area
We serve Placentia and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – cabinets and countertops in Placentia

Two to four weeks from demo to punch list. The variable is countertop fabrication, which typically runs three to five business days off-site after templating. Cabinets can’t be templated until they’re fully set, so rushing that step is what stretches timelines. Call (888) 300-3178 to schedule your free estimate and we’ll pair a realistic date to your specific job.
Only when plumbing, gas, or electrical lines are being relocated, or walls are being opened or removed. A straight swap of cabinets and countertops in the same locations typically doesn’t need a permit. We pull permits and pass inspections when the scope calls for them, and that’s in writing before work starts. Call (888) 300-3178 and we’ll confirm the permit question for your address.
In most Placentia kitchens, yes, and it saves real money. Keeping the sink and range lines in place often shaves two to four thousand dollars off the job compared to relocating them. The trade-off is design freedom: if the existing layout has a fridge blocking the best counter run, moving it may be worth the plumbing cost. We’ll show both numbers in writing.
Typically $14,000 to $45,000 for the full scope, with cabinet installation at $4,000 to $13,000 and countertops at $2,000 to $6,500 depending on material. Material grade and layout changes drive the biggest swings. Call (888) 300-3178 for an exact quote – estimates are free.
Our work is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. Cabinet and countertop manufacturer warranties ride alongside it and vary by brand. We put both in writing so you know exactly who handles what if something goes wrong. Call (888) 300-3178 and we’ll walk you through it.
Get a free estimate for cabinets and countertops in Placentia
Call (888) 300-3178 to book a free on-site estimate for cabinets and countertops in Placentia. A live person answers around the clock, and the visit takes about an hour: we measure the room, walk the existing plumbing and electrical, and hand you a written, line-item estimate with fixed pricing so the number you see is the number you pay. Plans and financing aren’t decided over the phone; they’re on paper when you have real numbers in front of you.
Written by the team at Groundwork Construction Co.












