







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Brea, CA: What It Costs and How Long It Takes
Concrete Driveways & Concrete Work in Brea typically runs $4,500 to $12,000 for a new pour, and most residential driveways take three to five working days from demo to the day you can park on them. A full replacement with removal of the old slab lands around $5,000 to $14,000. That range holds across the 92821, 92822 and 92823 ZIPs, though access and slope shift it. Call (888) 300-3178 and we’ll put a real number on your driveway.

How a Concrete Driveway Goes In, Stage by Stage

Concrete isn’t complicated, but the sequence is unforgiving. Skip a step or rush a cure and you’ll see it in cracks two winters later. Here’s the order we run, with the decisions that land on you along the way.
1. Site walk and layout (day 1)
We measure the drive, check the existing slab thickness and subgrade, and note where the grade falls toward the street or the house. You decide the finish, the width (a single-car drive is usually 10 to 12 feet, a double runs 16 to 20), and whether you want scoring, a border, or an apron. A slight slope toward the street is correct. Water running toward the garage is not, and correcting that is a grading decision, not a pour decision.
2. Demo and haul-off (day 1 into day 2)
Old concrete comes out with a breaker and goes into a dumpster on site. Older Brea slabs sometimes run thicker than expected, which adds hauling weight and time. If there’s rebar or wire mesh holding the old pour together, we cut it and remove it. You’ll want a plan for where cars park for the next several days, because the driveway won’t be usable.
3. Subgrade prep and formwork (day 2)
This is where most cheap driveways fail. We excavate down to stable soil, compact the base in lifts, and set forms to the finished grade. On a slope or against a hill, the base work gets deeper and may call for a retaining edge or drainage behind it. You approve the final grade line here, before anything is poured.
4. Reinforcement and the pour (day 3)
We set rebar or mesh, then pour, screed, and float. Control joints get cut at intervals so the concrete cracks where you won’t see it, on purpose. Finish happens on the wet surface while the crew is still standing there. If you’ve chosen a textured or broom finish, this is the moment it’s locked in.
5. Cure and clean-up (days 3 through 7)
Concrete keeps gaining strength after the crew leaves. It can typically take foot traffic within a day or so and a vehicle after about seven days, depending on weather. Hot inland Brea afternoons push us to keep it damp and shaded longer. We pull forms, clean the edges, and walk the finished job with you.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Shape Your Concrete Driveway
Concrete isn’t one product. These are the actual decisions a homeowner makes, and the honest trade-off of each.
- Standard broom finish: The most common and the most affordable option. Grippy and practical, with a fairly plain look that won’t win architectural awards but holds up well.
- Exposed aggregate: Aggregate is washed back to reveal stone texture. It hides dirt and looks richer, at roughly a 15 to 25 percent premium over broom finish.
- Saw-cut scoring and borders: Decorative lines and a contrasting border give a plain slab some structure. Small cost, noticeable effect.
- Slab thickness and reinforcement: Standard residential is 4 inches; heavier or vehicle-loaded drives push to 5 or 6 inches with rebar. Thicker and reinforced costs more up front and lasts longer.
- Base material and compaction: Crushed aggregate base compacted properly costs more than a quick scrape, and it’s the difference between a stable slab and one that settles and cracks.
- Drainage and grading: A swale, channel drain, or regraded slope keeps water away from the garage. Necessary on hillside lots, optional on flat ones.
Ready-mix suppliers in this market include Oldcastle and Quikrete products for smaller placements and patches. We’ll spell out the mix and thickness in writing before we pour so you know what you’re buying.

What Concrete Driveways & Concrete Work Costs in Brea, CA

A new concrete driveway here runs $4,500 to $12,000. A full replacement with tear-out lands at $5,000 to $14,000. Those numbers move based on a handful of real factors.
- Size: Square footage is the biggest driver. A short single-car pad sits at the low end; a long double-width drive pushes to the top.
- Existing condition: Thick, reinforced, or hard-to-break old concrete adds demo and hauling cost.
- Access: Tight lots and hillside streets can slow equipment movement and add labor.
- Grade and drainage: Slope work, retaining edges, and drainage corrections push a job toward the high end.
- Finish and reinforcement: Exposed aggregate and thicker reinforced pours cost more than a standard broom slab.
A written estimate should list the square footage, thickness, mix, reinforcement, base prep, demo, haul-off, finish, and grading. What it often leaves out is drainage engineering, retaining walls, and any work tied to a grading or building permit. Ask specifically what’s excluded. Our estimates are free and line-item, and the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Brea Homes Specifically Do to This Job
The flat, older core around downtown and the 92821 grid is where most of our concrete work in Brea happens: mid-century and 1960s-70s tract homes with driveways that have been patched, re-poured, and patched again. On those lots the real constraint is clearance and access, not grade. Toward Carbon Canyon and the 92823 fringe, a driveway is a different job entirely. Homes on the canyon-facing hillside streets need retaining walls and drainage designed around Santa Ana-wind fire exposure and post-fire debris flow, and that’s a permit conversation that rarely comes up on the flat side of the 57. Seasonal downpours after dry spells make slope stability and erosion control recurring issues up there. Brea has almost no greenfield left, so most drives we build are tear-outs and retrofits, and grading on a hillside lot often gets reviewed as part of a wider ADU Site Prep & Utilities in Brea plan when a homeowner is building at the same time.
Serving Brea, CA – Our Local Coverage Area
We serve Brea and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Concrete Driveways & Concrete Work in Brea

Most jobs take three to five working days from demo to finish, plus about a week before you drive on it. Weather and slope work stretch the schedule. Call (888) 300-3178 for a timeline on your specific driveway.
Often yes, especially when grading, drainage, or retaining walls are involved on a hillside lot. We handle the permit process and inspections for you. Call (888) 300-3178 and we’ll tell you whether your project triggers one.
Sometimes, if the existing slab is stable and the grading allows it, a new pour can go over a prepared base. But most older Brea driveways have failed for a reason, usually settling or poor base, and a proper replacement fixes it. We’ll tell you honestly which applies to yours.
Expect $4,500 to $12,000 for a new pour and $5,000 to $14,000 for a full replacement. Size, access, slope, and finish drive the number. Call (888) 300-3178 for an exact quote, and remember estimates are free.
Every project we complete is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. That’s one of the longest workmanship guarantees in residential construction. Call (888) 300-3178 to talk through the details before you commit.
Get a Free Concrete Driveway Estimate in Brea
Call (888) 300-3178 to schedule a free on-site estimate for Concrete Driveways & Concrete Work in Brea. We’ll measure the drive, talk through finish and drainage, and hand you a written line-item quote with no surprises. This is part of the wider Driveway & Pavers work we do, and a natural pairing with our Door Installation in Brea for homeowners finishing the front of the house. Learn more about how we cover Brea, or see the full scope on our Driveway & Pavers in Brea page.
Written by the team at Groundwork Construction Co.












