







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Santa Ana, CA
Most concrete driveways in Santa Ana run $4,500 to $12,000, and a standard pour takes 3 to 5 days from demolition to the day you can park on it. Concrete work on a Santa Ana lot usually means a tear-out and replacement rather than a pour over dirt, because the parcel already has a driveway, a garage apron, or a walkway in the way. Call (888) 300-3178 for a free on-site estimate; we’ll measure the slab, check the subgrade, and put a fixed number in writing before anything gets broken up.

How a concrete job actually runs, start to finish

Concrete is unforgiving. Once it sets, every shortcut underneath it is permanent, so the schedule below is built around the prep, not the pour. Here’s what the five stages look like on a typical Santa Ana driveway.
Day 1: Demo and haul-off
We break out the old slab with a skid-steer and hand tools where the pour runs tight to the house or a shared fence line. A standard two-car driveway and apron produces two to four truckloads of debris, and hauling is a line item on the quote, not a surprise. On a tight Santa Ana lot, the dumpster or debris pile often has to sit in the street, so we confirm parking and any city hauling rules before the crew arrives.
Days 1 – 2: Excavation and subgrade
This is where the job is won or lost. We dig out the old base, check for soft spots and old utility trenches, and compact the native soil in lifts. You’ll decide at this stage whether you’re staying at the existing grade or raising it, and that choice affects drainage toward the street, the garage apron lip, and whether the slab needs to tie into a walkway or stoop.
Day 3: Forms, base, and rebar
We set forms to the final width and slope, lay and compact a crushed aggregate base, then set rebar or welded wire mesh on chairs so it sits in the middle of the slab rather than on the dirt. Expansion joints go in against the house, the garage, and any fixed structure. This is the day to walk the layout with us; moving a form line is cheap now and expensive after the pour.
Day 4: Pour and finish
The ready-mix truck typically arrives in the morning. We place, screed, and float the concrete, cut control joints while it’s still green, and apply the finish you selected. The crew is on site until the surface is right, which for a two-car driveway plus apron is usually a five- to six-hour pour day.
Days 5 – 10: Cure, joint seal, and the drive-on date
You can typically walk on the slab in 24 hours and drive on it in about 7 days, though full cure takes 28. We come back to seal the control joints and do a final walkthrough. Any crack wider than a hairline or any ponding that shows up in the first rains is on us, which is what the 730-Day Done Right Promise is for.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The concrete options you’ll choose between
Most of the decisions on a Santa Ana concrete job come down to five choices. Each one moves the price and the lifespan:
- Standard broom finish vs. exposed aggregate. Broom is the default and the cheapest, and it grips well in the rain. Exposed aggregate looks better and hides tire marks, but it adds cost and takes longer to finish.
- 4-inch slab vs. 5- to 6-inch slab. A 4-inch slab suits foot traffic and light cars. If a heavy truck, RV, or a future ADU delivery is going to roll over it, we recommend 5 to 6 inches with heavier rebar.
- Rebar vs. mesh. Welded wire mesh is cheaper and fine for a walkway or a light-use apron. Rebar on a grid is the right call for a driveway that’ll see daily vehicle weight.
- Control joints vs. saw cuts. Both control where concrete cracks. Saw cuts look cleaner and are cut the day after the pour; hand-tooled joints are done during finishing.
- Base depth. Two inches of compacted aggregate is a minimum. On the clay-heavy soils we run into around the older parts of Santa Ana, four inches is a better investment and prevents the heaving that cracks slabs.
We pour ready-mix from established suppliers and, when a small repair calls for bagged product, we use Quikrete. The mix design matters more than the brand: a 4,000 psi mix with air entrainment holds up far better than a bargain-basement pour.
What Concrete Driveways & Concrete Work costs in Santa Ana, CA
Here’s the honest range for Santa Ana, broken out by typical scope:
| Scope | Typical price range |
|---|---|
| New concrete driveway installation (2-car, standard broom finish) | $4,500 – $12,000 |
| Full driveway replacement (demo + haul-off included) | $5,000 – $14,000 |
| Garage apron, walkway, or stoop pour | $1,200 – $3,500 |
| Slab repair or partial replacement | $800 – $2,800 |
Five variables push a job toward the top of that range:

- Square footage and grade. A long driveway on a slope needs more base and more concrete.
- Demo difficulty. Old slabs laced with rebar, tree roots under the pour, or a tight lot that won’t fit a skid-steer all cost more to remove.
- Soil conditions. Soft spots and old utility trenches mean more excavation and base.
- Finish and thickness. Exposed aggregate, stamped borders, and a 6-inch slab each add cost.
- Permit scope. A like-for-like replacement may not need a permit, but changing the grade, expanding impervious coverage, or tying into a new ADU or garage conversion usually does.
Your written estimate lists demo, hauling, base, rebar, concrete, finish, and joints line by line. It excludes things that may or may not apply: drainage improvements, retaining walls, moving an irrigation line or gas meter, and city permit fees if the scope requires them. Upfront pricing, no surprises: the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Santa Ana homes specifically do to this job
Santa Ana’s housing stock is a big part of why concrete work here runs differently than in a newer suburb. Much of the city is 1920s-to-1950s California bungalows and Spanish Colonial Revival or Craftsman homes in the Lacy and French Park/downtown historic neighborhoods, plus mid-century tract and apartment stock in ZIPs like 92707 and 92704. That means the driveway is usually surrounded by mature trees, an original garage, and a narrow shared approach, not an open lot.
The bigger factor is the city’s infill and ADU culture. Garage conversions and rear-lot ADUs are a Santa Ana staple, and a new driveway apron or garage slab often has to fit into a project that runs through the city’s preservation-sensitive planning review in the historic core. We’ve seen plenty of jobs where the concrete becomes a schedule item behind a permit, so it’s worth confirming your plan before we pour. When a driveway is part of a larger project, we coordinate the scheduling so the concrete isn’t curing while your contractor is waiting on it.
Climate also shows up in the concrete. Dry Santa Ana winds and summer inland heat pull moisture out of a fresh slab fast, which is why we cover and mist-cure pours during hot spells. The dry climate means stucco and slab cracks are common maintenance items, and the occasional winter rains can wash out a base if it isn’t compacted properly. That’s the failure mode we see most on older Santa Ana slabs: a shallow base under an original pour, heaved and cracked after decades of heat cycles.
Serving Santa Ana, CA – Our Local Coverage Area
We serve Santa Ana and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Concrete Driveways & Concrete Work in Santa Ana

A standard driveway takes 3 to 5 days from demo to walk-on, and about 7 days before you can drive on it. Larger jobs, or ones tied to a garage conversion or ADU, run longer because of permitting. Call (888) 300-3178 for a schedule estimate on your specific job.
A like-for-like replacement usually doesn’t, but changing grade, expanding impervious coverage, or pouring as part of an ADU or garage conversion does. We’ll tell you on the estimate visit whether your scope needs one and what the city’s review involves. Call (888) 300-3178 to sort that out before work starts.
Yes, in most cases. A driveway replacement stays clear of plumbing and framing, so the work is self-contained. The exceptions are when an irrigation line, gas stub, or downspout runs under the old slab, or when the project ties into an addition. Call (888) 300-3178 and we’ll walk the site.
New driveway installation runs $4,500 – $12,000, and a full replacement runs $5,000 – $14,000 depending on size, demo, and finish. Walkways and garage aprons start much lower. Call (888) 300-3178 for an exact quote – estimates are free and fixed.
Every concrete job we do is backed by our 730-Day Done Right Promise: if it’s not done right, we make it right. That covers workmanship, from base prep to finish and joint sealing. Call (888) 300-3178 to see the terms in writing before you sign.
Get a free estimate for concrete driveways in Santa Ana
Call (888) 300-3178 and we’ll schedule a free on-site estimate for your concrete driveways & concrete work in Santa Ana. We measure the slab, check the base, talk through finish options, and hand you a written line-item quote with a fixed price and no change orders. Calls are answered by a live person, day or night. If your plan is bigger, it’s often part of a full Driveway & Pavers in Santa Ana project, and homeowners often pair this with ADU Site Prep & Utilities in Santa Ana. You can also see our Driveway & Pavers service, our Santa Ana coverage, and Door Installation in Santa Ana if the work extends to your garage or entry.
Written by the team at Groundwork Construction Co.












