







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Tustin: What It Actually Costs and How Long It Takes
Concrete Driveways & Concrete Work in Tustin usually runs $4,500 – $12,000 for a full driveway pour and $5,000 – $14,000 when an existing slab gets torn out and replaced, with most jobs finished in 3 – 5 working days plus a week of cure time before you park on it. A standard Tustin driveway is about 400 – 600 square feet of 4-inch, 4,000-psi slab over a compacted base. Call (888) 300-3178 for a free on-site estimate.

Day by Day: How a Concrete Driveway Goes In

Concrete work looks simple until you watch a crew hit an old lateral or a buried cable. Here’s the real sequence we run, with what you’ll be deciding at each stage.
Stage 1: Site walk and layout (day 1, about an hour)
We measure the drive, check slope away from the garage, and mark the pour. You’ll confirm the width (single-car, double, or an apron that doubles as extra parking), the finish, and whether the drive meets the street flush or with a small curb reveal. This is also when we verify whether there’s a permit on file for the existing slab and whether the city will want a new one.
Stage 2: Demolition and haul-off (day 1 – 2, 4 to 8 hours)
Old concrete comes out with a skid-steer breaker or a saw-and-lift where access is tight. In Tustin Ranch, this is the stage where a careless saw cut into a post-tension slab can sever a cable under tension, so we locate and mark the cables before anything gets cut. Hauling off 6 to 10 tons of broken concrete is part of the bid, not a surprise line item.
Stage 3: Subgrade prep and formwork (day 2 – 3, one full day)
This is the stage most homeowners underestimate. We excavate to depth, compact the native soil, and bring in 4 to 6 inches of compacted aggregate base. On Tustin’s expansive clay, the base and drainage matter more than the concrete itself. You’ll decide whether you want a French drain or a channel drain at the low corner, and where the expansion joints land.
Stage 4: Rebar, inspection, and pour (day 3 – 4)
We set #4 rebar on a grid, tie it, and call for inspection where the city requires one. The pour itself is a half-day. You’ll pick the finish before the truck shows up: broom, exposed aggregate, or a light stamp. We control the slump and add a cure retarder if we’re pouring on a hot Santa Ana day, because concrete that dries too fast in Tustin’s dry fall weather cracks before it cures.
Stage 5: Cure, saw-cut, and seal (day 4 – 10)
We return the next morning to saw-cut control joints, then apply a cure-and-seal coat around day 7 to 10. Foot traffic is fine within 24 to 48 hours. Vehicles wait 7 days minimum, and we tell people to keep heavy trucks off it for 10. Those control joints are the difference between a hairline crack that stays cosmetic and a crack that becomes a trip hazard by year five.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
What You Choose Between: Concrete Specs and Finishes
The concrete itself is commodity. The specs and finish around it are where jobs differ, and where a $4,500 driveway and a $12,000 driveway diverge.
- Standard broom finish: The default. Good grip, hides tire marks, and costs nothing extra. It suits most Tustin Ranch tract driveways where the HOA already has one look for the street.
- Exposed aggregate: Pebble shows through the surface for better texture. It handles the dry season well but is harder to keep clean of the dust that blows through the Tustin plain each fall.
- Light stamped concrete: Only worth it where the architectural review board approves. Several Tustin Ranch villages require a plain finish, so check before you pay for stamping you’ll end up tearing out.
- 4-inch vs 5-inch slab: A 4-inch slab is fine for a car. If you park a truck or an RV, we go 5 inches with heavier rebar. The upgrade adds roughly 15 – 20% to material cost and maybe $400 – $800 to the job.
- Rebar vs wire mesh: Mesh is cheaper and adequate for light loads. Rebar on a 16-inch grid is what we recommend for any drive carrying real weight, and it’s a modest line item.
- 4,000-psi vs 3,000-psi mix: We pour 4,000 psi as standard. The higher strength mix is what we use where Old Town driveways meet a curb cut and the city inspects the apron.
For materials we spec Quikrete and Sakrete mixes where a bagged product makes sense, and Oldcastle for larger flatwork pours. Our technicians have up to 12 years of experience reading a pour, and that experience is what keeps a Tustin slab from cracking at year two.
What Concrete Driveways & Concrete Work Costs in Tustin, CA
A concrete driveway in Tustin runs $4,500 – $12,000 installed. Replacement runs $5,000 – $14,000 because demo and haul-off come first. Here’s what actually moves that number.

| Line item | Typical range |
|---|---|
| Concrete driveway installation (400 – 600 sq ft) | $4,500 – $12,000 |
| Driveway replacement (demo + new pour) | $5,000 – $14,000 |
| Demo and removal of an existing slab | $500 – $1,500 |
| Extra subgrade or clay soil correction | $300 – $1,200 |
| Drainage (French or channel drain) | $600 – $1,800 |
| Finish upgrade (aggregate or stamped) | $400 – $2,500 |
What pushes you to the high end: a driveway wider than 600 square feet, a slab that hides a failed base or old aviation-era debris under the northwest quadrant, PT-cable slabs in Tustin Ranch that require careful locating, a permit that pulls an inspection, or a drainage correction because the pour can’t slope to the street. What keeps you low: a simple single-car replacement over a stable base with a plain broom finish.
A written estimate from us is line-item and fixed, with the demo, haul-off, and finish all stated. It’s not included when: a hidden utility or lateral has to be rerouted, or a permit is required and the city adds plan-review fees. We tell you up front if either is a possibility on your property.
See the difference
Before
After
Before
After
Before
AfterOld Town Slabs and Tustin Ranch HOAs: Why This Job Is Different Here
Tustin splits cleanly between two markets, and concrete work swings between them. In Old Town (92780) off El Camino Real, the 1920s – 1950s bungalows sit on pier-and-beam or shallow slabs with original clay sewer laterals, so a driveway replacement often means a lateral inspection first. In the master-planned villages of Tustin Ranch (92782), the 1980s – 2000s tract homes sit on post-tension slabs, and those tensioned cables will punish a careless saw cut. We locate and mark before we demo.
The former Marine Corps Air Station hangars and surrounding base land in the northwest quadrant are a third case: contractors there regularly hit old aviation-era slabs and buried utilities, and a demo scope that starts as a driveway pour can turn into abatement work. And because Tustin sits on expansive clay that swells after winter rain, we build base and drainage to handle movement rather than pour over it and hope. Most Tustin Rancho HOA boards want a plain finish and a submittal before work starts, and we can pull the photo documentation for that review.
Serving Tustin, CA – Our Local Coverage Area
We serve Tustin and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Concrete Driveways & Concrete Work in Tustin

Most jobs run 3 to 5 working days on site, plus 7 to 10 days of cure before you park on it. A larger replacement with clay correction or drainage might stretch to 6. Call (888) 300-3178 for a timeline for your specific driveway.
Often yes. Flatwork that connects to a public street or curb cut, and any driveway apron tied to the right-of-way, typically requires a permit and inspection, and we pull it. Call us and we’ll tell you what your project likely needs before you sign anything.
Usually. Most Tustin Ranch HOAs approve a plain broom finish and require an architectural submittal before work starts. We supply the photos and specs for that review, and we steer you toward a finish the board will approve. Call (888) 300-3178 if you want us to look at your community’s rule first.
A standard driveway runs $4,500 – $12,000, and a replacement runs $5,000 – $14,000. The range depends on square footage, base condition, drainage needs, finish, and permit scope. Call us for an exact quote – estimates are free.
Every job is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in the residential construction space. Call (888) 300-3178 to schedule your free estimate.
Get a Free Estimate on Concrete Driveways & Concrete Work in Tustin
If you’re weighing a driveway replacement or new pour in Tustin, call (888) 300-3178. A real person answers around the clock, and we’ll set a free on-site estimate. We’ll measure the drive, check base and drainage, and leave you a written line-item quote with fixed pricing so the number you see is the number you pay. If your project is part of a full Driveway & Pavers in Tustin scope, or you’re also planning a ADU Site Prep & Utilities in Tustin or Door Installation in Tustin, we can put it all on one estimate. You can see our other outdoor work at our Driveway & Pavers service page, and we cover the whole Tustin area.
Written by the team at Groundwork Construction Co.












