







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Irvine, CA: What It Costs and How Fast It Goes In
A chain link fence in Irvine typically runs $3,500 – $9,000 installed, with most standard residential lots landing between $4,200 and $6,800. A straight 150-foot run of galvanized 6-foot fence with one walk gate usually takes two days: posts set on day one, mesh and hardware on day two. Concrete set time is what stretches it, not labor. Call (888) 300-3178 for a free on-site estimate and a written line-item quote.

How a chain link job actually runs, stage by stage

Chain link is the least glamorous fence on the market and the most predictable to install. That predictability is why we can tell you on the estimate visit roughly when you’ll be walking your dog behind a finished fence. Here’s the sequence.
Stage 1: Site walk and utility locating (same visit as the estimate)
We measure the run, note grade changes, gate locations, and anything buried near the line. Then 811 gets called for utility marking, which takes about two business days in Irvine. On older Woodbridge and Deerfield lots, irrigation lines and pool equipment runs are the usual surprises, and this is when you decide whether the line shifts a few feet or we dig carefully around them.
This is also where the property line gets settled. If you don’t have a recent survey, order one or have your neighbor agree on the line in writing before anyone digs. Fence disputes in Irvine HOA villages get expensive fast.
Stage 2: Demo and prep (half a day to a full day)
Old fence comes out, posts and concrete footings included. We haul it off. Corner and end posts get set in concrete at roughly 24 to 30 inches deep depending on soil and wind exposure, with line posts a bit shallower at consistent spacing. In Irvine’s semi-arid soil, that concrete cures fast in summer, and Santa Ana wind events are the reason we don’t skimp on corner bracing.
What you decide: how the fence handles slope. Racking the mesh to follow grade looks better on gentle yards; stepped panels cost more in hardware and labor but hold up straighter on steeper lots.
Stage 3: Framework and mesh (day two)
Top rail, tension bands, and mesh get pulled and tensioned with a come-along, not hand-tightened. This is the invisible quality line between a fence that stays flat for fifteen years and one that sags by year three. Our technicians have up to 12 years of experience and know exactly how much tension the mesh wants before it deforms.
Stage 4: Gates, hardware, and the walk-through
Walk gates get hinges, latches, and a drop rod if double. You test the swing yourself before we leave. Small adjustments on the spot are normal and free.
Stage 5: Concrete cure and aftercare
Footings cure over about 48 to 72 hours before real load. Keep dogs and kids off the posts for that window. It’s genuinely the only delay in the whole job, and it’s the one thing you have to manage after we’re gone. Everything we install is covered by our 730-Day Done Right Promise. If a post goes loose or a gate sags in the first two years, we come back and make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
Chain link isn’t one product. What you pick changes both the price and how the fence looks in ten years.
- Galvanized vs. vinyl-coated mesh. Plain galvanized is the value choice and holds up fine inland. Vinyl-coated (usually black or green) costs 15 – 25% more and looks far better against stucco-and-tile homes, which is what most of Irvine is. Coating also adds a layer between the steel and the air.
- Height: 4, 5, or 6 feet. 6-foot is standard for privacy and pets. Check your village’s architectural rules first; many Irvine HOA villages cap rear-yard fence height and dictate color.
- Gauge of wire. 11.5-gauge is residential standard. 9-gauge is heavier, pricier, and worth it if you have a big dog that leans on the fence or the fence lines a busy street.
- Framework weight. 1-5/8″ line posts and top rail are standard; 2-3/8″ is commercial-grade and overkill for most yards but right for long unsupported spans.
- Gates. Walk gate, double drive gate, or a self-closing pool-code gate. Pool-adjacent fencing has its own code requirements, so flag it early.
- Privacy options. Slats woven through the mesh or a top screening add cost but turn a chain link run into something a neighbor won’t complain about. If privacy is the whole point, though, a different material is usually the better answer; that’s a conversation, and our Fence Installation in Irvine page covers the wider scope if you’re comparing.
What Chain Link Fence costs in Irvine, CA
Plan on $3,500 – $9,000 for a full chain link install in Irvine. Per linear foot, most residential jobs price out between $22 and $38, gates included.

| Line item | Typical Irvine range |
|---|---|
| 6′ galvanized chain link, per linear foot | $22 – $30 |
| 6′ vinyl-coated chain link, per linear foot | $28 – $38 |
| Walk gate (3 – 4 ft) | $250 – $550 |
| Double drive gate | $700 – $1,600 |
| Old fence demo and haul-away | $300 – $900 |
| Privacy slats | $6 – $12 per linear foot |
Four things push a job to the high end: total linear footage, removal of an existing fence with deep concrete footings, vinyl coating and heavier gauge, and gates. Slope and rocky soil add labor. Permit fees, if a permit is required, land on top.
What’s in a written estimate from us: materials, labor, demo, haul-away, gates and hardware, and the permit line if one applies. No change orders later. Upfront pricing, no surprises. What it typically isn’t: survey costs, landscape repair after digging, and any HOA architectural review fees.
See the difference
Before
After
Before
After
Before
AfterWhat Irvine homes specifically do to this job
Irvine is a master-planned city built from the 1970s forward, and almost every fence here runs through HOA architectural review before a shovel touches dirt. In Woodbridge and Deerfield, that review can take weeks and it’s often about color, height, and setback details, not whether the fence is allowed. In Northwood, Westpark, and Woodbury the committees are similar. Contractors who don’t know the process get homeowners stuck in limbo.
Housing stock matters too. Older Woodbridge lots often have a 1980s fence at the end of its life with footings that fight back on demo. Newer Great Park and Spectrum townhomes have attached-wall and party-line issues, so a boundary fence there needs careful coordination with the neighbor and possibly the HOA. Weather adds its own pressure: dry Santa Ana wind events work loose anything under-tensioned, and the semi-arid climate is kind to galvanized steel compared to the coast. We work Irvine (ZIPs 92602, 92604, 92617, and 92619) and surrounding areas like Tustin and Santa Ana. You can see the full range on our Irvine service-area page.
Serving Irvine, CA – Our Local Coverage Area
We serve Irvine and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Chain Link Fence in Irvine

Most residential jobs take one to three days of on-site work, plus about a week if HOA architectural review or a city permit is required. A standard 150-foot run is a two-day job once materials and approvals are in hand. The only real wait is HOA review, and we flag that up front so you can plan around it. Call (888) 300-3178 and we’ll give you a realistic date range.
Many Irvine installations require a city permit, and virtually all require HOA architectural approval before work starts. Height, color, and location on the lot are the details that get reviewed. We handle the permit and review coordination as part of the estimate and quote the fee as a line item, so nothing surprises you mid-project.
In most cases, yes. Chain link posts go in with a spade or auger at each post location, so disturbance is limited to small holes rather than a trench. Irrigation lines and pool plumbing near the fence line are the one thing that needs locating first, and 811 marking takes care of that. Where a line does run through, we shift the fence or hand-dig around it.
Most Irvine yards fall between $4,200 and $6,800 for a 6-foot vinyl-coated run with a walk gate. Larger lots with a double drive gate, demo of an old fence, or privacy slats push toward the $9,000 end. Call (888) 300-3178 for an exact quote; estimates are free and line-itemized.
Our workmanship is covered by the 730-Day Done Right Promise, one of the longest guarantees in residential construction. If a post loosens, a gate sags, or hardware fails in the first two years, we come back and fix it. Materials carry their own manufacturer warranties, and we pass those along in writing.
Get a free Chain Link Fence estimate in Irvine
Call (888) 300-3178 and a live person answers, day or night. We’ll set an on-site visit, measure the run, and walk you through the options and HOA review requirements for your village. You’ll get a written line-item estimate with no surprises. If you’re also tackling exterior work, homeowners often pair this with Door Installation in Irvine or ADU Site Prep & Utilities in Irvine. Our Fence Installation service covers the rest.
Written by the team at Groundwork Construction Co.












